   Microsoft Network Client 3.0 for MS-DOS

   Introduction:
   -------------
   This document describes the procedure to setup the Microsoft Network
   Client for DOS driver on D-Link DE-528CT PCI Adapter.

   Location of Driver:   \NDIS2DOS\DE528.DOS
   ------------------

   Sample Configuration Files:
    ---------------------------
      PROTOCOL.INI (install creates this file)

          [network.setup]
          version=0x3110
          netcard=DE528,1,DE528,1
          transport=ms$ndishlp,MS$NDISHLP
          transport=ms$netbeui,MS$NETBEUI
          lana0=DE528,1,ms$netbeui
          lana1=DE528,1,ms$ndishlp

          [protman]
          DriverName=PROTMAN$
          PRIORITY=MS$NDISHLP

          [MS$NDISHLP]
          DriverName=ndishlp$
          BINDINGS=DE528

          [MS$NETBEUI]
          DriverName=netbeui$
          SESSIONS=10
          NCBS=12
          BINDINGS=DE528
          LANABASE=0

          [DE528]
          AdapterID=@52544c190011   ; required when multiple adapters
                                    ; are on one system
          DriverName=DE528$

   Installation Procedure :
   ----------------------
      Before you start with the installation procedure, make sure that the
      adapter is properly installed and configured. Similarly, make sure
      that your Microsoft Network Client is properly installed.
      (If not, The installation utility SETUP.EXE is located on Microsoft
      Network Client v3.0 for MS-DOS Disk. Run SETUP.EXE from Disk and the
      SETUP program screen will appear, and you must complete each of the
      questions. These options are specific to your needs. The installation
      procedure will transfer files to a specific directory on the client
      and modify existing configuration files to fit your specific needs.)

      1. Change to the Microsoft Network Client subdirectory, and run
         SETUP.EXE

      2. The screen will display some infomation. Press <Enter> .

      3. Respond to the screen prompts, select "Change Network
         Configuration", then press <Enter>.

      4. Move the highlight to "Add Adapter", press <Enter>.

      5. Select "Network adapter not shown on list below ...".

      6. Insert the driver diskette in floppy A, and
         specify your pathname A:\NDIS2DOS, then press <Enter>.

      7. Follow screen instructions to complete the process. Simply
         pressing <Enter> for each screen display will select the default
         options. Press <Enter> until you reach the display prompting you
         to reboot your system.

   NOTES:
   ------
      1. Parameters for the PROTOCOL.INI file:

         AdapterID : This keyword is provided by DE528, and is required
                     when more than one DE528 adapters exist on one
                     system.

      2. Installing Multiple LAN Adapters:

         There are two different method to complete it:

         (a) Under DOS mode, you can modify the AdapterID in file
             C:\MSCLIENT\PROTOCOL.INI by yourself.

         (b) Or you can also use the SETUP program  and follow above
             setup procedure step 4, but move the highlight to "Change
             Setting", then press <Enter>, the screen will prompt you to
             fill AdapterID value .
