DSL-2642B Release Notes



Firmware v2.10

Fixes:
1.WEP security mode connection failed
2.If using wizard to configure wireless encryption to WEP mode, 
the security mode of status will show NONE instead of WEP after restart the device.
3.The performance of IPTV via wireless is bad.
4.PS3 will encounter "router can not support ip fragment packet" during connection test.
5.Support PPTP and PPTP passthrough support more than 2 PPTP clients.
6.SETUP->Local Network: Add local network setting page.


=========================================================================================================================

Firmware v2.07

Fixes:
1[DMZ]If remote access web port is 80 port, suggest change DMZ Port to 8080 port
2[scheldules]the scheldules function can not take effect
3[RIP] Device WAN interface can not send RIP v1 information
4[QoS]The QoS priority queue function does not work normally.
5[IPOA]When edit the connection type from PPP to IPOA ,the IPOA connection will fail.
6[wireless status]wireless mac address is empty
7[Static IP]When edit the connection type from PPPOA to Static IP ,the Static IP connection can’t edit successful?
8[Dynamice IP Address Connection] Connection up time displays 'not support' in web UI.
9[Static IP(1483 Bridge IP LLC)] Connection up time displays 'not support' in web UI.
10[Wireless Info] Wireless info in status displays wrong.
11[Bridge mode] Change bridge mode to Dynamic IP Address mode will cause error.
12[PPPoE/PPPoA] PPP connection wll not disconnect automatically even do not send outgoing packets.
13[SSH] LAN client run SSH client software can SSH to CPE.
14[Reset Button] Time for Reset Button to factory reset is about 5s, not 10s.
15[Idle time] During wireless is turning on, set idle time and reboot, wireless will be turn off, the mac address of wireless will be empty in the status page and wireless light will be turn on, but very dim
16[Internet indicator] internet indicator doesn't blink when there are Traffic detected between LAN and Internet.
17[Internet indicator] Internet indicator light would become red at some cases abnormally
18[PPP/Internet]Internet indicator is blinking green when Internet traffic is not detected
19[PPP/Internet]Internet indicator is blinking red when PPP negotiation has not sucessfully complete
20[Status LED indicator]Status LED indicator is solid green when Internet traffic detected.
21[port mapping]adding port mapping does not take effect
22[Connect-on demand]the idle time does not take effect
23[Internet LED]When PPP negotiation or Dynamic/Static IP link has sucessfully complete and no Traffic detected between LAN and Internet,the Internet LED is blinking green with high frequency.
24[Wireless Security Test]The WEP(open type) does not take effect
25[Internet LED]Creaing a PPPoA or PPPoE connection with idle time=1mimute,Internet LED is always solid green when PC ping the Internet successfully
26[Port Forwarding/Access Control ] wan user can't ftp to CPE's internal ftp server by port 2121.
27[Access Controls]enable WAN FTP, user can ftp the DUT ,but we can't login in it
28[Bridge] Wan PC can open DUT's Web UI by using LAN IP address (192.168.1.1).
29[WPS]When set WPS to enable and then set security to WPA only, WPS will automatically change to disable.
30[Time and Day] Evenif daylight saving function enable or disable, time doesn't have any change.
31[FW downgrade] Firmware can't downgrade form au_2.06 to au_2.04.
32[Firmware ugprade]Firmware can not upgrade from new version to old version